When the surface has been prepared and all repairs carried out you are ready to apply your cellulose primer. Mixing ratio: 1 part cellulose primer – 1 part cellulose thinner this can vary depending on spray gun set up. Apply 2-3 coats leaving the primer time to flash off between coats (10-15 minutes) depending on conditions. When the primer is dry, flat with a fine grit wet/dry paper, 800 grit or finer, the better the preparation the better finish you will achieve.
Once you are satisfied with the primed surface blow any dust off with a blow gun, tack cloth and panel wipe the surface before you apply your top coat. Avoid leaving the primer overnight in a damp workshop if possible as primers are porous so could absorb moisture resulting in poor top coat adhesion.
👁️ Görüntülenme: 21